First depending on your model make sure that the on off switch is in the on position or the bail arm is in the down position.
Lg in door ice maker not making ice.
Lg ice maker stopped making ice in left door ice maker.
6 the refrigerator door.
If the refrigerator is plugged in and receiving the right level of water without making any ice this could be the issue.
I tried resetting small button under motor drive on icemaker etc.
I can reach into the top of the tray and feel that ice is in the tray.
Have a lg french door ice maker problem i installed new ice maker still no ice dispensing.
Tried the test button again no movement no water.
Tried the paper clip test and nothing.
If you set the thermostat any higher than 4 degrees f the ice maker will still produce ice but it will make it at a slower rate.
The ice maker leaking water inside door was told by repair person this is a common issue with lg refrigerator and that it would cost 300 to repair was told that after 1to 2 years this would have to be fix again he advised me to just turn off water to ice maker is this normal.
This test fill button will be on the ice maker itself.
Even though the ice maker will begin making ice when the freezer reaches a temperature of 19 degrees f lg recommends a minimum temperature setting of 4 degrees f for maximum ice production.
If the icemaker module is defective the ice maker won t make or dispense ice.
It takes approximately 12 to 24 hours for a newly installed refrigerator to begin making ice.
It has two ice makers.
Removing the in door ice bin.
Making fan like noise from the two vents that goes into the lower part of the door.
It is not the cubed ice selection button on the control panel.
Make sure that the compartment door is tightly closed.
Lg refrigerators only work.
The other is in the bottom drawer freezer.
The water dispenser works and after.
Press and hold the test fill button until the ice maker starts to turn cycle.
Let it sit for about 5 hours.
While you may want a professional refrigerator repair service to confirm this changing the ice level control board could prevent the need to replace the entire ice maker.
Close the ice compartment door and pull the handle upwards.
Set the ice maker switch to on or off.
Replaced the motor unit and when i powered up the fridge i could see the fingers rotate.
The water supply is turned on and no kinks should be in the lines.
To reset the ice maker make sure that.
If the icemaker module has ejector blades check to ensure that ice cubes are not stuck in the blades.
It s not dumping the ice.
It s just not dumping it.