If the water filter is not installed correctly the water will not flow and therefore no ice or water will come from the dispenser.
Lg french door ice maker not making ice.
Why lg refrigerator ice maker not filling with water 1.
Once the mold reaches the proper temperature the ice maker starts a harvest cycle by ejecting the ice cubes and refilling with water.
Turn on and reset the icemaker.
Set the ice maker switch to on or off.
The water filter on newer refrigerators need to be twist locked into place.
If you set the thermostat any higher than 4 degrees f the ice maker will still produce ice but it will make it at a slower rate.
It takes approximately 12 to 24 hours for a newly installed refrigerator to begin making ice.
For the ice maker on your lg refrigerator to function correctly it will need to reach a temperature of 4 f which is 20 c.
Proceed to our reset icemaker section of this article for step by step instructions.
Close the ice compartment door and pull the handle upwards.
If the ice maker is not working the icemaker mold thermostat might be defective.
Thaw ice maker 3.
Avoid any unnecessary panic until this time.
The power switch is located on the icemaker and is marked on and off.
Without filter or when the filter installed not properly in the filter housing water will not flow to the ice maker and water dispenser.
Freezer temperature is above 10 degrees f 12c if the freezer temperature is above 10 degrees fahrenheit 12c the ice maker will not produce ice cubes efficiently.
Make sure that the compartment door is tightly closed.
If the icemaker is on but the unit is not producing ice try to reset the icemaker.
Replace ice maker with replacement below ice maker replacement.
This is a very common issue with newer refrigerators.
Https amzn to 2jx1ipv if this v.
Open the ice compartment by gently pulling the handle downward.
If you have only just installed the refrigerator it may take up to 24 hours for the unit to reach this temperature.
Open the refrigerator door.
Inside the control module of the ice maker is a thermostat which monitors the temperature of the ice mold ice tray.
Water filter if during the test mode your ice maker didn t fill with water then check your water filter.
The freezer temperature should be set between 0 and 5 degrees fahrenheit 18 to 15c for the ice maker to work properly.
Reset ice maker 2.