Eliminate any item in between the sensors.
Lfftmaster garage door will not open light flash 10 time.
When the safety sensor is not properly aligned or something is obstructing the light beam the garage door will fail to close.
If one of the leds is not on the door sensors need to be replaced.
Disconnect all wires from back of motor unit.
The liftmaster garage door opener lights will flash for ten times.
Ten flashes of the light tells you there is a problem with the door safety sensor circuit.
This most likely indicates that the garage door sensors are out of alignment or there is something in the way of the sensors.
Once you know that the lock button is not the issue you ll want to check to see if anything is obstructing the sensors or if the sensors need to be realigned.
The light from the opener blinks 10 times to warn you about misaligned photo eyes.
Perhaps the most common issue for many homeowners if the safety sensors are not properly aligned the light will blink 10 times.
If one or both leds is blinking the sensors are misaligned.
Liftmaster motors will not operate when something obstructs the infrared beam between the safety sensors at the bottom of the garage door tracks.
Garage door openers made after 1993 are equipped with sensors positioned on both sides of the vertical rails.
Start by checking if.
When you see you garage door opener lights flashing and the garage door will not close it could be the lock button or the safety reversing sensors.
30 60 cm from back each of sensor.
An open door will not close if the infrared beam is broken.
Check if something is blocking the way of the safety sensor.
Inspect sensor wires for a short staple in wire correct wiring polarity black white wires reversed broken or disconnected wires replace attach as needed.
If you push the garage door opener switch when the sensors are obstructed or not aligned properly your garage door will reverse and the lights will blink 10 times.
Chat with a parts advisor.
If necessary you can close the garage door by pressing and holding the door control push bar until down travel is completed.
Garage door light flashing but won t close.
This will explain how to troubleshoot a garage door opener that won t close the door and blinks 10 times.
To troubleshoot your liftmaster safety sensors.
The main light will blink 10 times indicating a problem.
To fix this issue first locate the two photo eyes attached to your garage door and clean the lens using a soft microfiber cloth.
Need help ordering a part.
Look at the led s on both door sensors.
Fortunately resolving many of these problems can be done safely by the layperson and doesn t require specialized tools.
If your liftmaster garage door is stuck and won t open it is possible to troubleshoot it in a variety of ways.
They work by sending and receiving an invisible infrared beam.
Doors can get stuck due to problems with their power source photo eyes and track alignment among other things.